Shimano Steps BT-E6000, Dealer'S Manual

Page: 21 / 57

Installing and wiring the drive unit
Installing the drive unit
21
Installing and wiring the drive unit
„
Installing the drive unit
1
Align the three mounting holes (B) in the
drive unit (A) with those in the frame.
(A)
(B)
(A)
Drive Unit
(B)
Mounting holes
2
Insert M8 bolts, attach nuts from the
opposite side, and tighten them to the
designated torque.
Bolts and nuts are not included with Shimano
products. Use those supplied by the
manufacturer. For information on the
tightening torques, contact the manufacturer.
„
Drive unit wiring diagram
Below is an example of wiring on a carrier type battery.
(B)
(A)
(C)
(D)
(A)
Light connector
(B)
Speed sensor connector
(C)
E-tube connector for cycle
computers and motor units
(D)
Ferrite core
NOTE
Be sure to attach dummy plugs to any unused
ports.
•
The left illustration shows an example of
wiring.
•
The light connector can be used through
both ports
(A) .
•
The E-tube connector for cycle computers
and motor units can be used through both
ports
(C) .