Shimano Steps BT-E6000, Dealer'S Manual

Page: 23 / 57

Installing and wiring the drive unit
Installing the ferrite core (DU-E6001)
23
„
Installing the ferrite core (DU-E6001)
If a ferrite core is included with DU-E6001, install it by following the procedure described below.
Depending on the specifi cations, a ferrite core may not be included with DU-E6001, so installation is not required.
1
Install the ferrite core (A) on the power
cord (B) .
(A)
(B)
(A)
Ferrite core
(B)
Power cord
2
Make sure that the power cord is not
pinched and fi rmly secure the ferrite
core.
Then, fi x the ferrite core with the zip tie
(C) .
(C)
(C)
Zip tie
NOTE
•
Check that the ferrite core tabs are
fi rmly secured.
•
Do not cut off the excess portion
of the zip tie. The cut surface of
the zip tie may scratch the cable or
case.
•
Do not drop the ferrite core or
subject it to any shocks. Subjecting
the ferrite core to shocks will
cause it to break or crack,
rendering it unusable.
3
Position the ferrite core so that the
power cord fi ts inside the drive unit.
(a) For SM-BME60
(b) For SM-BME61
(a)
(b)