SECTION 2 – OPERATION
2-21
POWER TAKE-OFF (PTO)
The power take-off (PTO) on your tractor
transfers engine power directly to mounted or
trailed equipment.
All models operate through the standard 1 3/8 in.
(34.9mm) diameter, 6-spline output shaft rotating
at 540rpm, the speed at which most PTO driven
equipment is designed to operate.
Your tractor is equipped with 2-speed PTO so
that the symbol of “540” on the proof-meter
relates to 540rpm PTO speed with lower PTO
speed gear is selected, and “540E” symbol
relates to 540rpm PTO speed with higher PTO
speed gear is selected.
PTO CONTROL SWITCH
To engage the rear PTO, push the PTO control
switch
①
, and then rotate clockwise to set the
“ON” position.
To disengage the rear PTO, push the PTO
control switch, and then rotate counter-clockwise
to back the “OFF” position.
The PTO control switch must be in the “OFF”
position to activate the safety start system and
allow the engine to start.
IMPORTANT:
If the operator leaves the seat
without the shuttle lever in the “NEUTRAL”
position and with the PTO engaged, the engine
will shut off in approximately two seconds.
PTO MODE SELECT SWITCH
Your tractor can be select for “PTO mode
②
” for
TRANSMISSION PTO” and “PTO mode
①
” for
INDEPENDENT- PTO” by using the PTO mode
select switch
③
.
Transmission PTO means that the foot-operated
inching / clutch pedal allows stopping the tractor
and PTO motion.
Independent PTO means that it can be engaged
or disengaged, whether or not the tractor is in
motion.
To activate the Independent PTO, push the PTO
mode select switch
③
to outside. The indicator
lamp
④
on the switch tab will illuminate when
independent PTO mode is activated.
1
4
3
PTO “ON”
POSITION
PTO “OFF”
POSITION
Summary of Contents for ST460
