SECTION 3 – LUBRICATION AND MAINTENANCE
3-33
Changing the Front Axle Differential Case and
Final Reduction Gear Case Oil
NOTE:
The front axle differential case and final
reduction gear case oil should be changed after
every 300 operating hours.
1. Place a suitable container beneath the oil
plug.
With the oil at normal operating
temperature,
drain the oil by removing the
drain plug
①
. After
the oil has drained,
reinstall the drain plug and
discard the used
oil.
2. Remove the dipstick/filler plug
②
, on the
left-hand side of the axle housing.
NOTE:
To obtain correct oil level reading do not
screw dipstick into axle housing when checking
oil
level.
Fill the axle with SAE 80 hydraulic oil until
the oil level is between the full
mark and
the lower
end of the dipstick. Reinstall the
dipstick/filler
plug.
NOTE:
Approximate fluid capacity for the
differential
axle housing is 4 liters
3. Remove the drain plug
③
, from each final
reduction gear case. After the oil has drained,
reinstall each drain plug and discard the used
oil.
Remove the filler plug
④
, from each
final
reduction gear case and fill with SAE
80
hydraulic oil so that the oil level is at the
bottom
of the fill port opening. Reinstall
each filler plug.
NOTE:
Approximate final reduction gear cases
fluid
capacity is 0.9 liters each.
NOTE:
To ensure correct steering operation, the
stop
bolt
⑤
, should protrude a
minimum of
32mm
from the casing (standard FWD axle).
Summary of Contents for ST460
