Shibaura ST460, Operator'S Manual

Page: 91 / 126

SECTION 3 – LUBRICATION AND MAINTENANCE
3-24
HEAD LAMP
If any of the two head lamps fails to operate, the
bulb must be replaced. To change the bulb:
1. Open the tractor hood.
2. Disconnect the negative (-) battery cable
from the negative (-) battery terminal before
replace the fuses.
3. Pull up the connector
①
and rubber
②
the
housing.
4. Take off the spring.
5. Remove the bulb.
6. Install a new bulb and install the spring,
rubber and connector.
IMPORTANT: Be careful not to touch the bulb
with bare fingers. Oil from the fingers can
shorten the life of the bulb. Use a protective cloth
or glove when installing the new bulb.
TAILLIGHT / FLASHER WARNING LIGHT/SIDE
LIGHT
The tractor is equipped with two taillights ① , and
four flasher-warning lights ② , and two side-lights
③ , mounted on the ROPS.
To replace the bulbs:
1. Disconnect the negative (-) battery cable
from the negative (-) battery terminal before
replace the fuses.
2. Remove the two screws securing the lens to
the housing.
3. Remove the lens, and then remove the bulb.
4. Install a new bulb and reinstall the lens
and/or rim assembly.
1
2
2
1
2
3