Shibaura GM222, Operators Manual & Parts Lists

Page: 7 / 49

5
The handle is used to hold the machine in position and turn during the
operation with the grips held.
These are held when operating the machine.
This lever is used to apply the brake and stop the movement of the
machine body.
This grip is held to set the stand.
This is used when the transport tires are to be attached or removed
and supports the front roller and the lawn mower body.
This cover protects the operator against being accidentally caught by
the transmission belt. Never remove it during the operation.
This lever sets “ON” and “OFF” of the reel blade operation.
This roller is used to enable the machine to run during the operation
after the transport tires are removed.
These handles adjust the clearance between the bed knife and the reel
blade. There are two handles (left and right).
These tires are used for transporting the machine to the work place.
This tool is used to manually rotate the reel blade.
This cap protects the reel blade shaft.
These knobs (located on the left and right) adjust the working roller’s
height above the ground.
These knobs are used to move the front roller up and down in order to
adjust its height.
This roller keeps the reel blade at the proper height above the ground
to maintain a uniform height when cutting the lawn.
This roller removes the cuttings and controls the grass’s direction. It
then feeds the grass into the reel blade.
This blade is used for cutting lawn.
This knob changes the mode of the working roller: “normal rotation”,
“stop” and “reverse rotation”.
This switch starts or stops the engine. To start the engine, set it to “ON”
and set it to “OFF” to stop.
This mark to confirm the amount of the fuel in the fuel tank.
This container is filled with fuel.
This lever transmits the power of the motor and toggles between start
and stop. If it is not set to “ON” then the reel blade does not rotate.
This lever adjusts the engine speed.
This bucket catches the clippings and prevents the reel blade or machine
body from accidentally touching anybody’s body.
This knob is used to control the supply of the fuel.
This is used when the handle is pulled to start the engine.
This tool removes and trapped air and dust from in the fuel.
This cleaner removes dust from the engine’s air intake.
This reduces engine noise.
This lever is used to reduce the fuel’s air mix when the engine is started
from cold.
This gauge with its divisions is used to check the engine oil level or to
show if it has any dirt.
The cutting height is set by using the two screws and this gauge is pressed
against the front and rear rollers to set them at the specified height.
Name of Each Section and Function
Name Function
Handle
Grips
Brake Lever
Stand Grip
Stand
Front Cover
Reel Blade Clutch Lever
Rear Roller
Bed Knife Adjusting Handles
(Right) and (Left)
Transport Tires
Blade Alignment Tool
Reel Blade Shaft Cap
Working roller Height Adjustment
Knobs (Left and Right)
Front Roller Height Adjustment
Knobs (Left and Right)
Front Roller
Working roller
Reel Blade
Working roller clutch knob
Engine Hand Switch/Engine
Switch
Fuel Gauge
Fuel Tank
Main Clutch Lever
Throttle Lever
Bucket
Fuel Cock
Recoil Starter
Strainer
Air Cleaner
Muffler (Silencer)
Choke Lever
Oil Gauge
Cutting Height Gauge
Name of Each Section