2-7
2
Fn + F11 ( )
Turns the LCD screen on and off
Fn + F12 ( )
Forces your computer into System standby, hibernate, or
powered off
(See
Power Management
of Chapter 3 for more information.)
Using Optical Drive
Your computer is equipped with an optical drive allowing you to read from DVD and
CD and write onto CD-R/RW.
CAUTION FOR LASER
Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
Maximum output and wavelength of the laser: 108mW, 784nm(CD-R/RW)
6mW, 662nm(DVD-ROM)
CLASS 1LASER PRODUCT
LASER KLASSE 1
Handling Disk
•
Do not write on either side of the disk, particularly the non-label side. Data is
read/write from/onto the non-label side. Do not mark this surface.
•
Keep your disks away from direct sunlight, heat and excessive moisture.
•
Always hold the disks by the edges. Fingerprints, dirt or water on the disks can
cause noise or mistracking. If a disk is dirty or does not play properly, clean it with
a soft, dry cloth, wiping straight out from the center, along the radius.
Summary of Contents for PC-MC20 Series
