Sharp AR-C260, Operation Manual

Page: 57 / 140

SADDLE STITCH FINISHER
3-9
3
11
Raise the lever at the end of the staple box.
Remove the top staple if
it is bent. If bent staples
remain, a staple jam will
occur again.
12
Return the lever to its original position.
13 Reinstall the staple box.
Push the staple box in
until it clicks into place.
14
Push the stapler section back into the
finisher.
15 Close the front cover.
16 Push the stapler section back into the
finisher.
■ ■ ■ ■
Disposal of hole punch scrap (when the punch unit is installed)
1 Unlatch the saddle stitch finisher and slide
it away from the main unit.
2 Pull out the punch scrap collecting
container and empty it.
Discard the punch
scraps in a plastic bag or
other container, taking
care not to let the scraps
scatter.
3 Return the punch scrap collecting
container to its original position.
4 Push the stapler section back against the
finisher.
NOTE
Make a test print or copy in the staple sort mode to
ensure that stapling is performed properly
00-08.book 9 ページ ２００２年１１月８日 金曜日 午前９時３９分