User’s guide
HRP/D
-
38
-
HS
Tensioning and changing filament
13.1
SAFETY MEASURES
Before tensioning and changing the filament always take the
following safety measures:
1.
Switch off the foot switch by turning switch
F
to hand
operation.
2.
Clear the working surface.
3.
Switch off the control units one at a time (switch
L
).
4.
Turn off the main switch (switch
A
).
5.
Check that the heating elements and pressure bars in the
top frame are firmly attached.
6.
Allow the heating elements to cool for at least
10
minutes.
13.2
TENSIONING
1.
Turn the filament to the lowest position. (Only bottom
heating).
2.
Hold the end of the wire on the right with pliers and undo
screw in the wire pin.
(Use socket screw key
no. 2
)
3.
Pull the wire taut with pliers and tension the spring.
4.
Tighten the socket head screw firmly again.
5.
Cut off the end of the filament. Always leave 8-10 mm
projecting in order to be able to tension the filament
again.
Bend the projecting piece down.
Attention!
The end of the filament is sharp
.
13
10 minutes
Wire pin
Socket head screw
Summary of Contents for HRP/D
