User’s guide
HRP/D
-
16
-
HS
Operation
7
7.4
SWITCHING ON HEATING ELEMENTS
Each heating element can be switched on and controlled individually.
Switch on the desired control unit with switch (
L
). See
5.4
.
7.5
SETTING THE TEMPERATURE
The temperature of the filament can be set using the temperature regulator.
1.
When turning on the on/off switch, the display will show the value that was last
saved (keeping the machine on a certain value for >20 seconds will make it
remember this value).
2.
Press the right button (arrow up) to increase the value, up to 99 (keeping this
pressed in will make the value cycle much faster)
3.
Press the left button (arrow down) to decrease the value, down to 00 (keeping this
pressed in will make the value cycle much faster)
4.
Press both buttons at the same time to go directly to 00. Doing this also resets the
machine.
7.6
TROUBLE SHOOTING
Error message
Meaning
Solution
E1
The wire is loose (not connected)
Turn off the machine, check the filament, and reset the
machine
(see
§9.1
for changing filament)
Note: Between the values 00 and 04, this fault cannot be
detected
E2
The wire is loose (spark detection)
Check the connection of the filament
Check the filament, and reset the machine
This fault can also be reset by the arrow down button
(see
§9.1
for changing filament)
E9
Broken circuit board
Contact the supplier for a new circuit board
Empty display
No power
Alert a maintenance engineer
Check the fuse (see
§10.1
)
Check the power supply cable
Contact the supplier if necessary
80
Summary of Contents for HRP/D
