User’s guide
HRP/D
-
35
-
HS
Installation and removal of units
12
4.
Loosening the wiring:
a
Disconnect wires from the terminals on the rear of the
control unit.
b
Take the flat plug out of the distribution block.
Attention!
These plugs are secured.
Bend the safety clip up slightly in order to remove it. If
necessary first remove the plugs above it.
5.
Unscrew the two socket head screws. The screw at the
front is easiest to reach by unscrewing the frame plate on
the front.
6.
Remove the unit from the machine.
12.2.2
Installation
Installation is done in the reverse order.
4b
4a
5a
6
Summary of Contents for HRP/D
