SGMW Baojun 530, Service & Maintenance And Owner’S Manual

Page: 95 / 215

Lighting 87
5
Li
g
hti
ng
Turn and Lane Change Signal Lamp
To turn on the turn and lane change signal lamp, the ignition
switch must be in ON position.
Control lever upward = right turn signal lamp
Control lever downward = left turn signal lamp
After cornering, the turn signal interrupts automatically and
the control lever returns to the normal position.
To change the lane, you can pull the control lever to halfway
position (not reaching the turn signal lamp position) and
keep pulling it. After lane change, release the control lever
and it will return to the normal position automatically.
A rear turn signal lamp is integrated on the rear combination
lamp and the rear bumper of your vehicle respectively. If you
turn on the turn signal lamp with the liftgate open, the turn
signal lamp on the rear bumper will illuminate. This ensures
that a turn signal is sent to the drivers behind even when the
liftgate is open.
Steering Assist Lighting Function*
During steering, the two front fog lamp will illuminate to
provide auxiliary lighting if certain conditions are satisfied.
These conditions are:
1. The engine is running;
2. The vehicle speed is ≤ 35 Km/h;
3. The low beam lamp is turned on;
4. The steering wheel angle is >60° or the turn signal lamp
switch is turned on.
As the front fog lamp illuminates, the front fog lamp indicator
on the instrument panel also illuminates.
The steering assist lighting function deactivates and the
front fog lamps go out after a while under any of the
following condition:
1. The steering wheel angle is ≤ 30° or the turn signal lamp
switch is turned off.
2. The ignition switch is turned to a position other than ON.
3. The vehicle speed is > 40 Km/h;
4. The low beam lamp is turned off.
Front Fog Lamp*
When the ignition switch is turned to ON position, and the
headlamp functions as a position lamp or in a low beam
state, turn the ring button in the middle of the combination
switch to ON (connected) position to turn on the front fog
lamp. Turn the ring switch to OFF (disconnected) position to
turn off the front fog lamp.