SGMW Baojun 530, Service & Maintenance And Owner’S Manual

Page: 82 / 215

74 Instruments and Controls
The high beam indicator illuminates when the headlamp
high beam is turned on.
Position Lamp Indicator
This indicator illuminates when the position lamp is turned
on.
Engine Malfunction Indicator Lamp (MIL)
This indicator lamp illuminates when the ignition switch is
turned on but the engine has not started. This indicates that
the indicator lamp bulb can work normally. The lamp goes
out after the engine is started. This malfunction indicator
lamp (MIL) illuminates upon occurrence of any component
or subsystem fault related to the emission system. Once the
electronic control module (ECM) detects any fault, the
malfunction indicator lamp will keep illuminated. In case that
serious misfire is detected, the malfunction indicator lamp
will flash constantly. Serious misfire can cause damage to
the catalytic converter. In case of this, the electronic system
of the vehicle will switch to an emergency running procedure
so that you can continue the trip. However, we advise you
to go to the nearest Aftersales Service Center for fault
removal as soon as possible. If MIL illuminates for a while
and then goes out, it is normal, not indicating any system
fault.
Caution
If MIL illuminates, it indicates a fault that must be
noted. Continuous driving after MIL has illuminated
can cause damage to the emission control system,
and reduce fuel economy and vehicle controllability.
We advise you to go to the nearest Aftersales Service
Center for vehicle repair as soon as possible.
ABS Fault Warning Lamp
The ABS warning lamp will illuminate immediately the
ignition switch is turned on. It indicates that the system is
conducting self-inspection and the warning lamp bulb can
work normally. The warning lamp goes out several seconds
later.
When the ABS warning lamp gets into the following states,
please consult the nearest Aftersales Service Center.

Not illuminated as the ignition switch is turned on