SGMW Baojun 530, Service & Maintenance And Owner’S Manual

Page: 172 / 215

164 Vehicle Service & Maintenance
Seal Engine Number
It is on the engine cylinder block near the flywheel.
Method for Reading Vehicle Identification
Number Information from ECU
Method I: Use X431 Diagnostic Scanner
1. Connect the X431 diagnostic scanner with CAN BUS
II interface to the on-board OBD interface that is
generally located below the instrument panel at the
driver’s side.
2. Turn the vehicle power supply to ON position and turn
on the power of the diagnostic scanner.
3.
Click the “Start” button of X431 diagnostic scanner to
enter “Diagnostic Program” and select “Vehicle
Decoding Program” and “Start”, and then, select the
corresponding series. Select the latest diagnostic
software version, click “OK” and wait for the device to
reset and click “OK” again. Select the corresponding
model,
“Engine Control System” and the
corresponding electronic control system and then
click “OK”. Select “Version Information” to display the
VIN.
Method II: Use WDS Diagnostic System
1. Connect the data cable of diagnostic system to the
on-board OBD interface that is generally located
below the instrument panel at the driver’s side.
2. Turn the vehicle power supply to ON position and turn
on the diagnostic system.
3.
Select “Fault Diagnosis” to select the corresponding
model. Click to enter “ECM”, click “Module
Identification Information” and select “VIN” to display
the VIN.
Note: The methods for reading VIN with diagnostic
equipment of different brand or model may be different.
Please consult the equipment supplier.