SGMW Baojun 530, Service & Maintenance And Owner’S Manual

Page: 121 / 215

Driving and Controls 113
8
Dr
iv
ing
an
d Co
ntrol
s
In the sequence from the low voltage to the high voltage of
power, the operating positions are as follows: LOCK, ACC,
ON and START.
●
LOCK
Parking is carried out at the position. The working indicator
on the ENGINE START STOP switch does not illuminate
and the vehicle power is off.
●
ACC
Press the ENGINE START STOP switch at the LOCK
position; the position can be switched to the ACC position.
The orange working indicator on the ENGINE START STOP
switch starts to illuminate. At the position, power supplies of
some electrical accessories such as audio and cigar lighter
are connected.
If no operation is conducted, the system will automatically
return to the LOCK position 1h later, so as to reduce the
consumed power.
●
ON
Driving and start are conducted at the position.
Press the ENGINE START STOP switch at the ACC
position once; the position can be switched to the ON
position. The instrument cluster indicator illuminates, and
the orange indicator on the ENGINE START STOP switch
illuminates.
If you press the ENGINE START STOP switch once
(without other operations) at the ON position, the switch will
be turned to LOCK position.
●
START
At the ON position, turn the transmission at the neutral
position, and depress the clutch pedal . Then the green
indicator on the ENGINE START STOP switch illuminates.
Press the ENGINE START STOP switch once, and the
engine will start. After the engine starts, the ignition switch
keeps at the ON position.
●
OFF
Press the start switch once (vehicle speed < 2 Km/h).
Note
Never keep the engine idling at high speed for over 5
min.
Excess temperature will damage the exhaust system.
Note
If the transmission is not at the neutral position, the
engine cannot start.
Electronic Steering Column Lock*
As the electronic steering column lock is used to lock the
steering wheel, the vehicle having the ENGINE START
STOP function is equipped with the electronic steering
column lock at the same time. You can hear the operating
sound when the lock device is started or released.
If locking the steering wheel is required, following conditions
shall be met at the same time:
1.
The vehicle is motionless;
2. The ignition switch is at the LOCK position.
When conditions above are met, the steering wheel will be
locked immediately if any one of following actions occur:

Open or close the left front door.

Remote locking

Wait 24s later
If unlocking the steering wheel is required, you can just
enter the vehicle with the legal key and press the ENGINE
START STOP switch.
In the case that the steering column lock may be unable to
be released when it is in the wheel-deviation forward
directi
on, the instrument cluster will display “Failure in
locking of electronic steering lock” and buzz for prompt. At
this time, align the steering wheel, turn the ignition switch at
the ON position, and then switch to the LOCK position, to
make efforts to unlock the steering wheel. If unlocking fails,
check the vehicle.
Engine Starting
Before starting the engine:

Ensure that no barriers exist around the vehicle.

Ensure that all windows and doors are clean and
transparent.