SGMW Baojun 530, Service & Maintenance And Owner’S Manual

Page: 162 / 215

154 Vehicle Service & Maintenance
Caution
When using the jack, the vehicle may become unstable
and move, causing damage and personal injury.
Please use the correct jack in normal state.
Before lifting, have all passengers leave the vehicle
and stay away from traffic.
The jack is used for wheel replacement only.
Do not jack up the vehicle on a sloped or sliding
ground.
Use the jack at the jack lifting point closest to the
wheel that needs to be replaced.
Stop the wheel on the diagonal with wedges, blocks or
stones so as to avoid vehicle moving.
Caution
Before using the jack, make sure that the parking
brake is pulled up, the transmission is at Gear 1 or
reverse gear.
Avoid replacing wheels at traffic-intensive locations.
Jump Start (Dead Battery)
The vehicle with a low battery can be started by using the
battery of other vehicles by the means of jump start.
If the battery is dead, please contact the Aftersales Service
Center for handling unless you confirm that you have
enough electrical knowledge and you can safely complete
this work.
Caution
Do not start the vehicle by the means of pushing or
dragging. Otherwise, it may damage the catalytic
converter and the transmission and even personal
injury.
Preparation before Jump Start
1. Pull up the parking brake.
2. Ensure that the gearshift lever is at the neutral.
3. Turn off all electrical accessories.
Note
Turn off the audio system before jump start of the
vehicle. Otherwise, the audio system will be damaged.
Please turn off unnecessary electrical devices when
the vehicle is running at low speed for long time (in
case of traffic jam).
Jumper Cable Connection
In case of jump start of the vehicle, connect the jumper cable
in the following order:
1.
Clip one end of the first jumper cable to the positive
terminal of the powered battery. (There is a “+” mark
on the battery housing or the terminal)
2. Clip the other end of the jumper cable to the positive
terminal of the dead battery. (There is a “+” mark on
the terminal)
3. Clip one end of the second jumper cable to the
negative terminal of the powered battery. (There is a
“-” mark on the battery housing or the terminal)
4. Connect the other end of the cable to the body ground
of the vehicle that has no electricity.
5. While jump start, it is allowed to start the engine of the
vehicle providing jump start power supply. Try to start
the engine of the vehicle that has no electricity within
one minute, and do not turn the ignition key more than
5s each time. After start, keep the rotation speed at
2000 (r/min) for several minutes.
6. To remove the jumper cable carefully in reverse order,
remove the negative cable first and then the positive
cable.