SGMW Baojun 530, Service & Maintenance And Owner’S Manual

Page: 23 / 215

Keys, Doors and Windows 15
1
K
eys,
D
oors
a
nd
W
ind
o
w
s
2. After the engine hood is opened slightly, stretch out
the hand to the lower side of the engine hood front
edge. Pull the engine hood release handle upward as
shown in the figure to open the engine hood
completely.
3. Separate the engine hood prop rod from the fixing
clamp. Plug the free end of the prop rod in the slot.
Closing Engine Hood
1. Support the engine hood to prevent it from closing,
and take the prop rod out from the slot. Then, fix the
rod in the fixing clamp.
2.
Make sure that your or other persons’ hands or other
body parts are away from the engine compartment,
engine hood and vehicle body edges.
3. Slowly drop the engine hood, and release it when the
engine hood front edge is about 30 cm vertically from
the top crossmember of the water tank to let it fall
freely.
4. Always check and confirm that the engine hood is
locked in place.
Caution
● Pull the engine hood front edge before driving to
make sure that the engine hood is locked.
● Do not pull the engine hood release handle when the
vehicle is moving.
● Do not drive the vehicle when the engine hood is
open. If the engine hood is open, the driver’s sight will
be blocked.
Driving when the engine hood is open may cause a
collision accident, damaging your vehicle or other
properties or leading to casualties.
Outside Rearview Mirror
Please check the visual field of all rearview mirrors before
driving.
Adjusting Outside Rearview Mirror
The power outside rearview mirror adjustment switch is on
the left side of the instrument panel. Adjust the outside
rearview mirror as per the following steps:
1.
Select the rearview mirror to be adjusted. Press the
“L” or “R” on the selector switch to adjust the left or
right outside rearview mirror.
2. Press the buttons (
△
) around the setting pan to adjust
the selected rearview mirror upward, downward,
leftward and rightward.
3. After adjustment, recover the selector switch to non-
pressed state (both ends not pressed).