Page 46 of 60
SGM-101F - programming menu
10.79 M79 - Relay output programming
In this menu it’s possible to set the function associated to the relay output.
Available settings:
0. No Signal
14. Energy NET Pulse
1. Poor Signal
15. MediaVel=>Thresh
2. Not Ready (No *R)
16. MediaVelo<Thresh
3. Reverse Flow
17. ON/OFF via RS845
4. AO Over 100%
18. Timer (M51 Daily)
5. Fo Over 120%
19. Timed Alarm #1
6. Alarm #1
20. Timed Alarm #2
7. Reverse Alarm #2
21. Batch Total Full
8. Batch Controller
22. Timer by M51
9. POS Int Pulse
23. Batch 90% Full
10. NEG Int Pulse
24. Flow Rate Pulse
11. NET Int Pulse
25. Disable Relay
12. Energy POS Pulse
13. Energy NEG Pulse
RELAY Output Setup
6. Alarm #1
10.80 M80 - Batch output programming
In this menu it’s possible to set the batch activation mode.
Available settings:
0. Key Pressing
1. Serial Port
2. Al3 Rising Edge
3. Al3 Falling Edge
4. Al4 Rising Edge
5. Al4 Falling Edge
6. Al5 Rising Edge
7. Al5 Falling Edge
8. Timer-Periodical
9. Time-daily
Batch Trigger Select
0. Key Pressing
10.81 M81 - Batch volume programming
In this menu it’s possible to preset the batch volume value.
To preset the batch volume proceed as follows:
press “ENTER”.
Set the predetermined volume. Change the digit with
“UP ARROW” and move the cursor to the right with “SCROLL”.
Press “ENTER” to store.
With M80 set to “0. Key Pressing“, the display will show the message
“Press ENT When Ready”; pressing “ENTER” starts the batch cycle.
During the batch cycle, the display shows:
1
the predetermined volume value.
2
the performed cycles Bach number (including the cycle in progress).
3
the batch status: ON active, OFF inactive.
4
the increase in the batch counter.
By pressing “ENTER” will stop the batch cycle.
FlowBatch Controller
1000 m3
FlowBatch Controller
>
500
100 m3
Press ENT When Ready
100 m3 0015
ON 37 m3
1
2
3
4