Installing the Housing
Hook the housing over the top of the mounting plate and fasten through predrilled holes
in the back of the housing.
Model 600 component:
housing (with curtain assembly removed)
Tools/Materials:
°
permanent marker
°
safety eye wear
°
drill
°
#10 x ½ self tapping pan head screws with 5/16 hex head
NOTE: Always keep your head higher than the housing while mounting. This makes the
job easier and helps to avoid head injury.
To mount the housing on the mounting plate:
NOTE: The curtain sits in the housing during shipping. Prior to mounting the housing,
use the door key to open the housing door and remove the curtain.
1. Hook the top of the housing return over the beveled edge of the mounting plate.
NOTE: If the housing does not fit over the mounting plate, GENTLY pry along the
length of the beveled edge on the plate just enough to fit the housing tightly over
the plate.
2. Verify that the center mark on the housing meets the centerline of the elevator
frame.
3. If the center lines do not meet, gently tap the sides of the housing to slide it along
the mounting plate, being careful not to damage the housing.
4. Verify that the housing fits tightly on the mounting plate.
11
