SEW-Eurodrive MOVIPRO ADC, Operating Instructions Manual

Page: 174 / 244

9
Operation
Status and error messages
Operating Instructions – MOVIPRO
®
ADC
174
Status LED Possible cause Measure
Flashing
• Device has detected the baud
rate, but is not addressed by
DP master.
• Device was not configured in
DP master or configured in-
correctly.
• Check the PROFIBUS ad-
dress set in the device and in
the configuration software of
the DP master.
• Check the project planning of
the DP master.
Lights up red • Connection to the DP master
has failed.
• Device does not detect
PROFIBUS baud rate.
• Bus interruption
• DP master not in operation.
• Check the PROFIBUS DP
connection of the device.
• Check the configuration of the
DP master.
• Check the cabling of your
PROFIBUS network.
Status LED S1 EtherNet/IP™ and Modbus/TCP
Status LED Meaning
Off The device does not yet have any IP parameters.
Flashing
green/red
The device performs an LED test.
Flashing
green
There is no controlling IO connection.
Lights up
green
There is a controlling EtherNet/IP™ IO connection.
Lights up red Conflict detected in the assigned IP addresses. Another station in the
network uses the same IP address.
Flashing red The previously established controlling IO connection is in timeout
state. The state is reset by restarting communication.
Status LED S1 DeviceNet™
Status LED Possible cause Measure
Off Not switched on/offline • Device is offline.
• Device is performing a DUP
MAC check.
• Device is switched off.
Flashing
green
Online and in operational mode • The device is online and no
connection has been estab-
lished.
• DUP-MAC check performed
successfully.
• A connection has not yet been
established with a master.
• Missing, incorrect or incom-
plete configuration.
22749055/EN – 04/2016