SEW-Eurodrive MOVIPRO ADC, Operating Instructions Manual

Page: 16 / 244

2
Safety notes
Installation/assembly
Operating Instructions – MOVIPRO
®
ADC
16
2.7 Installation/assembly
Ensure that the device is installed and cooled according to the regulations in this doc-
umentation.
Protect the device from excessive mechanical strain. Ensure that components are not
deformed and that insulation spaces are maintained, particularly during transportation.
Electric components must not be mechanically damaged or destroyed.
Observe the notes in the chapter "Mechanical installation".
2.7.1 Restrictions of use
The following applications are prohibited unless explicitly permitted:
• Use in potentially explosive areas
• Use in areas exposed to harmful oils, acids, gases, vapors, dust, and radiation
• Operation in applications with impermissibly high mechanical vibration and shock
loads in excess of the regulations stipulated in EN 61800-5-1
• Operation at installation altitudes above 4000 m above sea level
Devices with a system voltage of phase to ground of 300 V or phase to phase of
500 V can be used at an altitude of more than 1000 m above sea level up to a max-
imum of 4000 m above sea level under the following conditions:
• The nominal continuous power is reduced due to the reduced cooling above
1000 m, see chapter "Technical data"
• Above 2000 m asl, the air and creeping distances are only sufficient for over-
voltage class II according to EN 60664. If the installation requires overvoltage cat-
egory III according to EN 60664 you have to reduce the overvoltages on the sys-
tem side from category III to II using additional external overvoltage protection.
• If a protective electrical separation is required, then implement this outside the
device at altitudes of more than 2000 m above sea level (protective separation in
accordance with EN 61800‑5‑1 and EN 60204‑1)
22749055/EN – 04/2016