SEW-Eurodrive MOVIPRO ADC, Operating Instructions Manual

Page: 172 / 244

9
Operation
Status and error messages
Operating Instructions – MOVIPRO
®
ADC
172
Code Meaning Possible cause Measure
SF2 Error in external periphery Check the cabling of the di-
gital inputs and outputs as
well as the connections of the
communication package.
SF3 Error while loading the applic-
ation module Non-enabled application
module loaded • Set parameter P802
"Factory setting" of the
"PFA-..." power section to
"Delivery state".
• Load an enabled applica-
tion module into the
"PFA-..." power section
SF10 Error in Application Configur-
ator communication Configuration with Application
Configurator not completed Complete the configuration
with the Application Configur-
ator and load it into the
device.
SF20 Error during data backup,
data backup on SD memory
card failed Start data backup again.
SF21 Error during data backup,
data backup on SD memory
card failed SD memory card is write pro-
tected Remove write protection from
SD memory card.
SF22 Error during data recovery,
data recovery to device failed Start data restoring again.
SF23 Error during data recovery,
data recovery to device failed Controller not inhibited Set the device to one of the
following states:
• Controller inhibit (A1.1)
• Safe torque off (A1.U)
SF99 Internal system error
SF110 Actuator voltage overload
error Actuator voltage overload Check the cabling of the di-
gital inputs and outputs.
SF120 Error due to overload in
sensor voltage of group 1 Overload sensor voltage
group 1 Check the cabling of the di-
gital inputs and outputs.
SF121 Error due to overload in
sensor voltage of group 2 Overload sensor voltage
group 2 Check the cabling of the di-
gital inputs and outputs.
22749055/EN – 04/2016