15
Assembly of the oar
Screw coupler with front shaft, then insert the rear shaft into the oar locks from the outside of the boat, join
them together by screwing the coupler with rear shaft. The coupler is then placed on the inside of oar locks
to prevent the oar from sliding into the water.
Inflation
Inflate the boat’s chambers in numbered sequences (1) and (2) then (3), (4) and (5). It is very important to follow the
numbered sequence: failure to do, so could result in an improperly inflated boat. You can use a hand or foot
operated air pump, or a low pressure electric pump to inflate the boat; it is recommended to use the foot pump
delivered with the boat. Do not use high-pressure air compressors. Inflate each air chamber in number sequence until
all chambers are full.
Warning: Do not over inflate in one time; it is harmful for the boat body. And over inflation of the chambers can cause
the boat to burst or cause damage to the boat body’s seams.
