14
The Wooden floor (option)
The amount of floorboards delivered with the boats:
How to place the floorboards
Between each floorboard you have to stick an inside-joiner. Place the inside-joiners with the broad side up (See
Drawing 1). With each boat there are two side joiners which you have to place at the sides of the floor boards in the
savings. These joiners make sure that wooden floor is stabilized even with waves.
Start with number 1, push this as far in the nose until the valve base of the keel is n the middle of the saving in this
floorboard.
3)
Now place the last board number 3 or 4, push this one so far as possible under the transom.
3.3)
For the models having two inside joiners: Place an inside joiner on board number 1. Push board number 2
inside the joiner. Pull up number 2 and 3 a bit. Now push down both boards carefully. (See drawing 3)
3.4)
For the models having 3 inside joiners: Place an inside-joiner on board number 1 and push number 2 in it.
Place another inside-joiner on board number 2 and push number 3 in it. Pull up number 3 and 4 a bit and
place the other between until both boards fit in it. Now push down both boards carefully. (See drawing No.3)
You will notice that the first couple of times you place the floorboards it will not go easy. After a while it will all
go easier as the material will stretch.
How to set Motor Mount
Set the mount when inflated only half. It is difficult to set motor mount when fully inflated.
Model
XPBFX230
XPBFX270
XPBFX320
XPBFX380
Floor board
3
3
4
5
