Servomex SERVOTOUGH Oxy, Operator'S Manual

Page: 36 / 145

24
© Servomex Group Limited. 2020 01910001B_8
4.7
The Menu screen
Note:
Some of
the menu screens referenced below may not be available: refer to the note at
the start of
Section 4.
The Menu screen provides access to other screens in the menu structure, and is displayed by pressing
the
so� key when the Measurement screen is displayed.
Figure
8 -
The Menu screen
Use the and
so� keys to highlight the required screen op�on, then press the so� key to
display the selected screen:
Scr ee n
Use
View
Select this screen to view the O
2
measurement pre and post pressure
compensa�on
readings and the percentage flow level.
Set up
Select this screen to select the communica�ons type, configure the auto
valida�on/calibra�on target range, enter a cross
-
interference compensa�on, switch
pressure compensa�on on/off, select the display units, set up flow sensor parameters
and trip levels, set up the mA output parameters and ranges and the relay energised or
deenergised se�ngs.
Calibrate Select this screen to calibrate or validate the analyser and to view calibra�on history.
Alarm
Select this screen to set up the measurement alarms and set the alarm follow op�ons,
unlatch alarms and view the measurement alarm status.
Se�ng
s
Select this screen to change analyser se�ngs (password, display language and so on).
Service Select this screen to calibrate/check the mA outputs and check the relay signal outputs.
Status
Select this screen to view ac�ve and historical fault, maintenance required and service in
progress (SIP) messages.
A
lterna�vely, press the so� key to display the Measurement screen again.
4.8
The Settings screen
Use the and
so� keys to highlight the required screen op�on, then press the so� key to
display the selected screen, as shown below:
Scroll bar: see
Sec�on 4.5