-48 VDC Remote Power Manager
Installation
23
Installation and Operations Manual
Connecting to the Unit
Serial (RS232) port
The -48 VDC Remote Power Manager is equipped with an RJ45 Serial RS-232 port for attachment to a PC or
networked terminal server using the supplied RJ45 to RJ45 crossover cable and RJ45 to DB9F serial port adapter as
required.
Ethernet port
The -48 VDC Remote Power Manager is equipped with an RJ45 10/100Base-T Ethernet port for attachment to an
existing network. This connection allows access to the unit via Telnet or Web.
The -48 VDC Remote Power Manager is also configured with the following network defaults to allow unit
configuration out-of-the-box through either Telnet or Web:
NOTE:
When installed on a DHCP enabled networks, the following network defaults
do not
apply because the Remote Power Manager
(CDU) ships with DHCP support enabled.
IP address:
192.168.1.254
Subnet Mask:
255.255.255.0
Gateway:
192.168.1.1
The local PC network connection must be configured as noted below:
NOTE:
For instructions about reconfiguring the network connection, contact your system administrator. A restart may be required for the
reconfiguration of your network to take effect.
IP address:
192.168.1.x (where x is 2-253)
Subnet Mask:
255.255.255.
Modem port
The -48 VDC Remote Power Manager is equipped with a DB9 male modem serial port for connection to an external
modem using the supplied DB9 female to DB25 male serial cable.
