CHAPTER 7: GEARMOTOR SPECIFICATIONS
Motor type
Page 15/16
Adjusted via the
power supply voltage
Dimensions and weight
Max gate weight
Power supply
Absorbed current
Absorbed power
Traction and thrust force
Motor power adjustment
Gate speed
Gear ratio
Protection class
Operating temperature
CHAPTER 8
POWER CUT - manual gate release -
8.1 A
Fit the release key into the lock on the front panel of the motor
unit and turn it anticlockwise by a half turn.
Push the release flap hard downwards until the release
mechanism is triggered.
The gate can now be moved by hand
CAUTION: The gate must not be resting on the
mechanical end stops, otherwise the force required to
perform the release manoeuvre would break the flap
8.1 B
To relock the gate, lift the release flap and remove the key from
the lock cylinder.
Open or close the gate a few cm by hand until the stop pinion
locks, ensuring the limit switch has been pressed.
1/2
216 mm
2
7
2
m
m
248 mm
8
2
m
m
CHAPTER 6: RZ/24 F FLASHING LIGHT
!
NO
WHEN REPLACING LIGHT BULBS,
ALWAYS USE BULBS WITH
MIN. SPECIFICATIONS:
24V - 25W - E14
2 x 0,75 mm²
POWER SUPPLY
RG58
ANTENNA
CS/07 SR12.07
OPTIONAL CABLE
CONNECTIONS
230 Vac
OK
!
CAUTION:
WE RECOMMEND THAT THE POWER SUPPLY CABLE BE POSITIONED INSIDE A CONDUIT WHICH IS NOT
ACCESSIBLE BY THE USER. IF, ON THE OTHER HAND, THERE ARE ANY ACCESSIBLE PARTS, THESE MUST BE
DOUBLY INSULATED FOR THE USER'S PROTECTION; A CABLE CLAMP MUST ALSO BE USED TO PREVENT THE
SAID CABLE FROM BEING TUGGED OR RIPPED.
RZ/99
SR 10.99
L-SHAPED
HOLDER
In the event of a power cut, the gate can be moved manually by releasing the motor as shown above.
CAUTION: if the gate is in an intermediate position (one of the limit switches has not been pressed) when
power is restored, the next time the open command is sent, the manoeuvre will be performed in
deceleration mode for a maximum time of 300 s. If, during that time, the limit switch is still not reached, the
subsequent closure manoeuvre will be performed normally. To prevent this, the gate must be moved during
the power cut to either the fully open or the fully closed position (so that one of the limit switches is
pressed).
SIN
C
E
1
96
5
M
E
R
C
U
R
IO
/5
2
4
A
I
E
irreversible
24 Vdc
IP43
-20 °C ÷ +60 °C
216 X 272 X 248 mm - 9,6Kg
1:28
500 Kg
1,4 A
170 W
400 N
10 m/min
