3.5 SETTINGS OF EACH MICROSWITCH
OPERATION
SETTING
Page 10/16
Pre-flashing enabled:
the flashing light switches on 3 seconds prior to
the gate opening.
ENABLE/DISABLE
FLASHING LIGHT
PRE-FLASHING
Step-step function disabled
During opening: if an OPEN/CLOSE command is sent, it is ignored
and the gate goes on opening.
During closure: if an OPEN/CLOSE command is sent, gate motion
stops for a few seconds and then the gate starts opening again.
During open gate pause: overrides the pause time, making the gate
close immediately.
ENABLE/DISABLE
STEP-STEP
OPERATION MODE
IMPACT
WITH OBSTACLE
Force limitation deactivated:
impact with an obstacle is not detected
and the motor goes on driving the gate.
CAUTION: If the microswitch programming is modified, the new settings are rendered
Active by switching the control unit off then on again.
DESCRIPTION OF OPERATION
CAUTION: with the force limitation feature deactivated,
other safety devices must be adopted (e.g. sensitive edge),
which must be compliant with regulations in force.
Input for photocell active during both closure and opening:
if the
photocell is obscured during opening, the gate stops moving, but starts
again as soon as the photocell is clear; if the photocell is obscured
during closure, the gate will stop moving, and then start opening again.
Force limitation activated:
in the event of an impact with an obstacle,
whether during opening or closure, an encoder system detects the
impact, stops the gate and then reverses it by 10cm see Page 12.
Pre-flashing disabled
: the flashing light switches on at the same time
as the gate starts opening.
SIN
C
E
1
96
5
M
E
R
C
U
R
IO
/5
2
4
A
I
E
1
2
O
N
S
W
2
1
2
3
4
O
N
S
W
1
1
2
3
4
O
N
S
W
1
CLAMP 18
OPERATION
MODE
1
2
3
4
O
N
S
W
1
Input sensitive edge:
both in closure and opening the gate reverses
the motion by 10 cm
1
2
3
4
O
N
S
W
1
1
2
O
N
S
W
2
SLOW-DOWN
ENABLED
1
2
O
N
S
W
2
1
2
O
N
S
W
2
1
2
3
4
O
N
S
W
1
1
2
3
4
O
N
S
W
1
1
2
3
4
O
N
S
W
1
1
2
3
4
O
N
S
W
1
Step-step function enabled
during the opening and closure: all command open/close are executed
according to what settled with dip1 SW1
during open gate pause: a command open/close overrides the pause
time, making the gate close immediately
STEP-STEP
OPERATION
MODE TYPE
The commands open/close set the sequence
OPEN/STOP/CLOSE/OPEN
The commands open/close set the sequence
OPEN/STOP/CLOSE/STOP/OPEN
Slow-down activated
Slow-down deactivated
