2.3 OPENING THE MOTOR UNIT
Remove the fastening screws on the side of the
unit
Remove the motor cover
Remove the plastic casing from the motor unit
2.4 MOTOR POSITIONING
2.4 A
Screw the 4 grub screws into the relevant housing
Position the motor on the base plate, inserting the threaded part of the J bolts
through the slots in the base
Level the motor by adjusting the grub screws
Fit the washers onto the bolts and screw on the 2 nuts without tightening them
completely. These bolts must not be secured until the tooth rack is in its final
position
2.5 RELEASING THE MOTOR
2.4 B
Cut small holes in the rubber seals, so that they grip each of the cables properly.
If this operation is not carried out
and insects get inside the unit, a short circuit may occur, causing irreparable damage to the ECU.
Fit the release key into the lock on the front panel of the motor unit and turn it anticlockwise by a half turn
Push the release flap hard downwards until the release mechanism is triggered
Page 5/16
SIN
C
E
1
96
5
GRUB SCREWS
NUTS
WASHER
1/2
M
E
R
C
U
R
IO
/5
2
4
A
I
E
