Part 1—The Diviner 2000 display unit and probe
Setup mode
Sentek Pty Ltd
ACN 007 916 672
Page 13
Caution
Sensor head should not be placed directly in water. Always use the
sensor inside an access tube.
Adjusting the vertical scale units (inch, cm)
Note
: the Probe Type field cannot be changed. It is always 10cm/3.9 inch.
The type of Units can be changed at any time as the data is store in
independent units.
Ø
To adjust the vertical scale units
1.
Decide on your preferred setting of Imperial (inches) or metric
(centimeters) .
2.
Use the up/down arrow keys to move the cursor to the
Units
field.
3.
Use the left/right arrow keys to toggle between the metric and imperial
options.
4.
Press
ENTER
to save or use the up/down arrow keys to move on to the
next option.
Setting the default screen
This option selects which graph type is displayed after a scan is performed.
Ø
To adjust the default screen
1.
Use the up/down arrow keys to move the cursor to
Default screen
field.
The
Default screen
function is highlighted.
2.
Use the left/right arrow keys to select from the available options; table,
single or summed, (refer to page 22).
Note:
Sentek recommends that you set the ‘summed’ graph as the
default screen.
3.
If you select
None
the unit will stay in
Scan mode
after completing a
scan.
Adjusting the LCD contrast
Note: The
BACKLIGHT
button may enhance the readability in low light
conditions.
Summary of Contents for Diviner 2000
Page 6: ......
