USER MANUAL – Z-PASS1/Z-PASS2
57
Default URL for user pages:
https://<IP_address>
FILE TRANSFER/Protocol
Protocol used for File Transfer:
FTP/SFTP, SFTP, FTP
FTP/SFTP
FTP Port
TCP Port for FTP protocol
21
SFTP Port
TCP Port for SFTP protocol
22
NETWORK REDUNDANCY/Enable
Flag
to
enable/disable
the
“Network
Redundancy”
functionality, that is using the
Ethernet interface as the primary
interface to access the Internet and
the Mobile interface as the
secondary interface, if the access
through the primary interface
becomes unavailable
OFF
NETWORK REDUNDANCY/Ping
Address
IP Address used as ping destination
to check if access to the Internet
through the primary interface
(Ethernet) is available.
This address shall be different from
the one set for “DNS Server”
parameter, otherwise an error is
shown (see figure below).
8.8.4.4
WATCHDOG/Enable
Flag
to
enable/disable
the
watchdog functionality
ON
WATCHDOG/Timeout (s)
Watchdog timeout, in seconds;
when watchdog is enabled, if it’s
not refreshed for this amount of
seconds, the system will be
rebooted.
Possible values are in the range
[30..3600].
60
DEBUG LOGS/Enable
Flag to enable/disable the debug
logs
OFF
COM1/Mode
Operating mode of the COM1 serial
port
Possible values: RS485 | RS232
This parameter is available only for
Z-PASS1-IO
and
Z-PASS2-IO
products.
RS485
One note about the “DHCP” parameters:
the “DHCP” parameter can be set to “ON” only if the “DHCP Server” parameter of the “Router
Configuration” page is set to “OFF” (see paragraph 18.8).
