USER MANUAL – Z-PASS1/Z-PASS2
21
7
Upgrading the firmware by USB pen
Z-PASS firmware can be upgraded by means of a USB pen; a pen drive formatted with FAT32 file-system is
needed
.
The procedure is the following:
1)
download the FW file from one of the following links:
http://www.seneca.it/products/z-pass1
http://www.seneca.it/products/z-pass2
the downloaded file is a .zip file; extract the FW file from it;
the FW file shall have a name like the following:
SW003900_xxx.bin
2)
copy the file into the root of the USB pen
3)
switch off the Z-PASS
4)
insert the USB pen into the USB#1 port
5)
switch on the Z-PASS; the upgrade procedure will take some minutes to be completed; during this
time, the Z-PASS MUST NOT be switched off; during the procedure, the Z-PASS will be rebooted
several times; also, during the procedure, several LEDS will blink simultaneously
3
6)
the upgrade procedure is ended when only the LED “RUN” is blinking
4
7)
remove the USB pen
8
Discovering the Z-PASS IP address
Z-PASS devices come out of the factory with the default IP address 192.168.90.101, on the Ethernet (LAN)
network interface.
If this address is changed,
and forgotten
, it can be retrieved using the “Seneca Device Discovery”
application (SDD), as shown in the following figure:
3
This applies only to products with HW revisions IO and R01; in details: for IO HW revision, all LEDs will blink
simultaneously, except for Power, LAN/WAN, COM and modem LEDs; for R01 HW revision, RUN, VPN and SERV LEDs
will blink.
4
Also SERV and VPN LEDs might blink, depending on the Device configuration and status.
