There are 10 additional screw / fixing points in the surface of the Tabletop to Drill and then fix with TX25 Screws
STAGE 5:
Using two clamps secure one of the END Plates vertically (WITH HINGES ALREADY ATTACHED) to one end of the 600 Tabletop.
USE BLOCK “A” to check that the END Plate is PERPINDICULAR to the rear face of the Tabletop Surface. It will be easier to clamp
the Tabletop and End Plate if you are the edge of a Table / Work Bench. When looking along the back face of the End Plate there
should be NO gap between BLOCK A and the End Plate. You may need to adjust the location of the clamps on the top edge of
End Plate and under the table to find the most “SQUARE” position.
WHEN CLAMPED TO THE WORK BENCH / TABLE – A GAP AT THE TOP OR BOTTOM OF BLOCK “A” MEANS THE PLATE IS NOT PERPINDICULAR
ZERO GAP TOP AND BOTTOM MEANS THE PLATE IS PERPINDICULAR / SQUARE
Use the BLOCK to make sure that the End Plate does not extend beyond the line of the Side Panel on both sides.
The outside face of the End Plate should also be flush with the end of the Tabletop. Once all components are aligned, secure the
End Plate to the Tabletop with the remaining Hinge Screws. The screws should be placed in the CENTRE of the Hinge Holes. The
End plate should remain flush with the end of the Tabletop.