INSTALLING 350 and 500 LEGS ONTO YOUR TABLETOP
Please note that you will only be able to use 200 Legs and EITHER 350 OR 500 Legs on a 600 Tabletop. You will need to remove /
unscrew one set of legs on a 600 Tabletop if you would like to change height! On the 1200 Tabletop you can fit 200 / 350 AND
500 Legs and fold them / store when one set is not in use.
Select your 350 or 500 Leg Components. The Installation process is the same for 600 and 1200 Tabletops. On a 600 Table you
only have space for 1 x Set of Legs!
350 Leg Set – 500 leg Set
Place 2 x T nuts into the CIRCLE markers on the back face of the CURVED Leg Components.
Turn your Tabletop over so you see the underside and place your 350 or 500 Leg against the side panel. Use an M10 x 40 mm
Button head bolt and a large washer to hold the Leg to the side panel.
THIS BOLT SHOULD BE FINGER TIGHT!
Use the Bolt Hole
closest to the MIDDLE of the Tabletop as shown below. Take your 350 OR 500 Curved Leg Component with the T Nut. The T NUT
should be on the INSIDE of the Tabletop. SLIDE this until the Vertical edge ALIGNS with the Vertical Edge of the attached leg.
The Vertical Edges of BOTH Leg Components should face the END of the Tabletop as shown. Use an M10 x 40 mm Button head
bolt to hold the Curved component to the Vertical Leg.
THIS BOLT SHOULD BE FINGER TIGHT!
This will allow you to manipulate
the two components in the next stage.
Rotate the Tabletop onto one side so that you can see the Inside of the Curved Leg component. Manipulate both components to
align them in all places. The Vertical / Straight Edges should be flush. The Join should be closed. The Slot should be flush of 0.5 /
1 mm clear to allow the leg to fit WITHOUT any friction against the Curved Leg component. You will see Hinge marker lines.
These are ONLY GUIDES and may appear stepped / Offset top and bottom! when all the components are properly aligned by EYE
and FEEL!