BOLTING TWO TABLETOP END PLATES TOGETHER
CREATING A DOUBLE TABLE DROP OFF WHEN USING 350 OR 500 LEG SETS
Step 1:
Attach one of your Tabletops to a Ramp. Make sure the Leg Set used is the same height and bolted secure at 12 Nm. Attach the
Joining Blocks as shown below. Place Joining Block one on either side of the Tabletop to create a REST / LEDGE for the other
Tabletop. It is easier if the blocks are a little loose at this stage as this will help when locating the second bolt.
Unfold the Leg Set on the second Tabletop and secure with the bolts at 12 Nm. Turn the Table so that the Legs are at the Drop
Off End. REST the end of the second Tabletop on the Blocks as shown below. Place the second bolt by finger first and then
tighten both bolts to 12 Nm. Repeat on the other side. When TWO Tabletops are joined together there should be ONE Leg set at
the Middle JOIN and ONE at the DROP OFF END. Before use make sure that all bolts are tight.
STEP 2:
We recommend BOLTING the END PLATES together to add additional strength to the join between two Tabletops. Manipulate
the END plates so you can locate a Bolt through one side and into a T Nut in the opposing plate. Tighten by finger to catch the
thread (and avoid cross threading) before using a Hex key to tighten the bolts. This give a super strong join between Tabletops.
You may find it easier to loosen the bolts on the joining plates OR attach one of the joining plates THEN connect the END plates
– then Tighten the joining plate bolts – THEN install the second plate!