Place two hinges inbetween the GUIDE Lines. Ensure the Join is closed and all parts aligned. Place one screw into the CENTRE of
the MIDDLE Hole of the Hinge on one side. Place a second screw in the opposite Middle Hinge hole. This screw should be 1 mm
OFFSET from the CENTRE of the hole towards the Long Rear Edge of the hinge. This will help pull the components together.
Place two more screw into the centre of the holes on one side and repeat the process of OFFSETTING the final two screws by 1
mm to pull the two components together. IF you OFFSET the screws too much the Leg will not sit flat and want to bend inwards.
Repeat the process to install the second hinge.
INSTALLING THE SMALL STABILISING FOOT
Take one of the Small Feet. Place this as shown below so that the higher part is on the INSIDE of the Tabletop. The Rough /
MESH face should face the End of the Table. Firmly push this in place or TAP with a hammer to fully seat the Foot. The Vertical
section and the foot should be FLUSH on the Bottom. Please note you can get replacement parts when they wear out.
Take a 4 mm Drill bit and use a piece of tape to mark the depth of hole to drill for a 4 x 30 Screw. Drill at a slight angle to avoid
breaking the Drill bit in the hole! Fix the foot to the leg with a 4 x 30 mm Stainless Steel Screw. Keep constant pressure to avoid
ROUNDING the head of the screw. Stainless Steel is SOFT!
REMOVE THE LEG AND FOLD THE HINGED CURVED COMPONENT. ROTATE THE TABLETOP ONTO ITS
OTHER EDGE AND INSTALL THE SECOND 350 or 500 LEG