ASSEMBLING YOUR 600 TABLETOP
STAGE 1:
Time to assemble approximately 1 – 1.5 Hrs
Select all the components with 13 mm holes through the plywood. Lie them on a flat surface so you can see ALL of the CIRCLE /
ROUND Markers around the holes. Place the T nuts into
ALL CIRCLED
Holes ONLY!
Place the Small Screws into the holes in the T Nuts and fix them to the Plywood. The Screws MUST be placed VERTICALLY!
STAGE 2:
Take BOTH the END Plates and 1 x Cross Baton. Find a completely flat surface and clamp the Baton to the End of the 1 x END
Plate as shown below. This will create a RIGID Angle to help screw the HINGES to the END PLATE ONLY. Places the Hinges inside
the Marker Lines on the END Plate. Make sure that the hinge is 90 degrees and tight into the corner formed by the back plate
and baton.
Start in the middle hole and place the screws 1 mm OFF centre TOWARDS the Outside Long Edge of the Hinge. Fill the remaining
holes by placing the screw in the centre of holes and repeat the process on the 2
nd
Hinge. REMEMBER – DO NOT SCREW THE
HINGE TO THE BATON
. Remove the Clamp and the Baton. Repeat the process to install the two remaining hinges into the
other END Plate. Place these components to the side.
STAGE 3:
Take the 2 x Side Panels and 2 x Cross Batons. Place the Cross Batons in the Vertical Pockets inside the Panels.