CREATING A DOUBLE TABLETOP WHEN USING 350 OR 500 LEG SETS
Step 1:
Attach one of your Tabletops to a Take OFF Ramp as shown above with the correct size of Leg Set. Make sure the Legs are bolted
and secure at 12 Nm. Attach the Joining Blocks as shown below. It is easier if the block is a little loose at this stage. Hook the
other Tabletop to the Landing Ramp. With TWO people lift the second Ramp and Tabletop so the Tabletops connect in the
middle. The second Tabletop should now be resting on the Blocks. Place the other joining block bolts by hand first and the
tighten both to 12 Nm. When TWO Tabletops are joined together BOTH the LEGS should be in the MIDDLE of the STRUCTURE.
Before use make sure that all bolts are tight.
STEP 2:
We recommend BOLTING the END PLATES together to add additional strength to the join between two Tabletops. Manipulate
the END plates so you can locate a Bolt through one side and into a T Nut in the opposing plate. Tighten by finger to catch the
thread (and avoid cross threading) before using a Hex key to tighten the bolts. This give a super strong join between Tabletops.
You may find it easier to loosen the bolts on the joining plates OR attach one of the joining plates THEN connect the END plates
– then Tighten the joining plate bolts – THEN install the second plate!