OmniHub CMP100 – User Manual
Page
34
of
106
1. Bypass mode routes whole input transport stream towards IP or RF output.
Bypass mode activation cause output channel will be occupied only by this
stream. Any attempt of routing other stream/service towards this channel will
show error. This can only be done when you click the icon on the TS. Bypass
cannot be on the single service only.
2. Multiplex mode is the counter part of bypass mode. This mode allows the
administrator to perform the following operations:
a. Routing single service towards output channel will results in SPTS creation
b. Routing services towards single output channel will results in MPTS creation
c. Routing service/s AND stream/s towards single output channel will results in
MPTS creation
To use
Bypass
OR
Multiplexing mode on stream level
click the
(cog) icon. There
will have always a BaseBoard selection for the IP output and other Output option
depending on the module inserted. Select the correct Output and Channel you want to
output the Stream. Put a tick on Multiplex or Bypass on the Channel you want to output.
Do not forget to click the Apply
button on the right side to make the change takes
effect.
To use
Multiplexing mode on service level
click on
(pencil) icon. There will have
always a BaseBoard selection for the IP output and other Output option depending on
the module inserted. Select the correct Output and Channel you want to output the
Service. Put a tick on Multiplex on the Channel you want to output, you can output