Selco Genesis 2200 PMC, Repair Manual

Page: 35 / 54

71
800 Read filter
Lets you filter current and voltage readings.
Minimum 1, Maximum 5, Default 1
802 Starting filter
Allows the control of the guard limits to be enabled with an adjustable delay in relation to the arc striking.
Makes it possible to filter the striking phase (consult the “Guard limits” section).
Minimum 0.0s, Maximum 10.0s, Default 2.0s
803 Output filter
Makes it possible to disenable the control of the guard limits in advance of the natural closing of the weld.
Makes it possible to filter the extinction phase (consult the “Guard limits” section).
Minimum 0.0s, Maximum 10.0s, Default 2.0s
12.3) “INFO” screen (set-up 501)
Allow to display of a series of system data.
1 System type board
2 Board Control board
3 Software Software version (Control board)
4 S/N Serial number
5 Power supply Power supply
6 Working time System operation time
7 Welding time System welding time
8 Gain adjust Calibration of the system
9 μ P Microprocessor
10 DSP DSP (Digital signal processor)
11 FP Control panel
12 WF Wire feeder
13 WU Cooling unit
14 RC Remote control
15 RI Robot interface
16 PC PC interface
17 ST TIG Torch
18 MB MIG/MAG torch
19 Software versions
The lack of the software version shown alongside a device (---) indicates lack of communication with it, and correct operation is
therefore not guaranteed (consult the “Diagnostics and solutions” section).