Selco Genesis 2200 PMC, Repair Manual

Page: 34 / 54

70
12) ADVANCED SET-UP (cod. 358 menu' Serv)
12.1) List of set up parameters (MMA)
2 (Hot start) Slope-up
Minimum 0.01s, Maximum 2.00s, Default 0.08s
4 (Hot start) Slope-down
Minimum 0.01s, Maximum 2.00s, Default 0.80s
201 No-load voltage
Minimum 12V, Maximum 80V, Default 65V
203 Antisticking enable
Permits enabling or disabling of the antisticking function.
The antisticking function permits reduction of the welding current to 0A in the event of a short circuit occurring between
the electrode and the piece, protecting the gun, electrode and welder and guaranteeing safety in the condition that has
occurred.
ON Antisticking active
OFF Antisticking not active
0.1÷2.0 The short circuit time before the antisticking function intervenes
Default 0.5s
501 Info
Allows the display of a set of information related to the system.
Consult the “Info" screen” section.
701 Current calibration
Allow the calibration of the system (consult the “System calibration” section).
702 Voltage calibration
Allow the calibration of the system (consult the “System calibration” section).
704 Offset calibration
Lets you calibrate the system (consult the “Offset calibration” section).
753 Reading n ° phase power supply
754 Reading voltage power supply
800 Read filter
Lets you filter current and voltage readings.
Minimum 1, Maximum 5, Default 1
12.2) List of set up parameters (Standard MIG/MAG, Pulsed MIG/MAG)
501 Info
Allows the display of a set of information related to the system.
Consult the “Info" screen” section.
656 Management WU
Off No active
1÷600 Manual Mode
START WU - Torch button
STOP WU - Not activate welding machine (t=1÷600)
REGOLATION WU - 100%
On Active
START WU - Switch On welding machine
STOP WU - Switch Off welding machine
REGOLATION WU - 100%
701 Current calibration
Allow the calibration of the system (consult the “System calibration” section).
702 Voltage calibration
Allow the calibration of the system (consult the “System calibration” section).
704 Offset calibration
Lets you calibrate the system (consult the “Offset calibration” section).
753 Reading n ° phase power supply
754 Reading voltage power supply