− 55 −
① Display the Camera Basic Setting screen on the satellite monitor. (See 2-6, ② .)
Confirm there is no misconnection or hardware damage if an error is detected during the
communication or IC checks.
If the camera positioning is "NG", display the Camera Position Setting screen (Figure 2.6 Ⅱ)
and adjust the position. (See 3-3.)
The shutter speed can be adjusted automatically. (See 2-6, ② , Ⅲ & Ⅳ .)
Settings such as the shutter speed and mean brightness are mutually dependent. First set the
shutter speed after adjusting the camera position. Focus adjustment is not possible. If the focus
is not right even though other settings are appropriate, replace the ASSY CCD CASE.
FIG. 3. 1 b CAMERA BASIC SETTING screen
② Lay the test sheet print correctly on the field sheet, pattern side down, with the " ◎ " mark in the
center and the " ○ " mark on the monitor side. Do not move the sheet until Camera Basic
Setting has been completed.
③ Display the Camera Basic Setting screen to check communications between the NAOMI 2 game
board and the camera board. If communication is normal, check the camera board ICs and the
firmware version. Perform automatic shutter speed adjustment, and measure the mean
brightness, focus value, and centered positioning of the camera relative to the field.
<<CAMERABASICSETTING>>
CommunicationOK
BootVersion1.000
BootChecksumOK
XXXXXXXX
ProgVersionX.XXX
ProgChecksumOK
XXXXXXXX
IC3MemoryTestOK
IC4MemoryTestOK
CCDRegisterOK
ShutterTimeXXXX
BrightnessXXX
FocusXXX
CameraPositionOK
LIGHTBALANCE
CAMERAPOSITIONSETTING
CAMERASHUTTERAUTOSETTING
CAMERASHUTTERSAVE
->EXIT
SELECTWITHSERVICEBUTTON
ANDPRESSTESTBUTTON