Figure A
DMD Ground Cables
(Location may vary)
Plasma DMD Assembly
DMD Power Cable
14-Pin DMD Ribbon Cable (J-2)
Display Controller Board
(
Needed for ColorDMD
)
26-Pin Ribbon Cable (J-1)
5v Power Cable (J-3)
Carefully remove the translite from the backbox and then lower
the speaker panel to the position shown in Fig. A to gain access
to the backbox.
ALL RIGHTS RESERVED - PATENT PENDING - COPYRIGHT 2013 - COLORDMD DISPLAYS LLC
STERN White Star
Installation Instructions
Be sure to turn
OFF
the power to the pinball machine before
installing the ColorDMD display.
Tools Required
:
Remove the eight DMD assembly mounting screws.
Remove
the original DMD assembly from the game and store it in
a safe place
.
1
2
3
STEP
STEP
STEP
Disconnect the DMD power cable from the DMD and from CN2 on
the Display Power Supply Board in the backbox. Also disconnect
5v power cable at J-3 on Display Controller Board.
Completely
remove the DMD power cable wire harness from the game
.
Congratutions on the purchase of a new ColorDMD display. The ColorDMD
will enhance your pinball machine by introducing
color
to the dot matrix
display graphics produced by the game.
Disconnect both ribbon cables from J1 and J2 on the Display Controller
Board.
Remove the Display Controller Board from the metal
bracket on the DMD assembly
.
1/4" Nut Driver
STEP
4
•
!
