Sega Bass Fishing STD, Owner'S Manual

Page: 45 / 94

42
8 - 4 REPLACING THE VOLUME
In the Test Mode, if the value variation of ROD X and ROD Y does not match with reel (rod) opera-
tion, the cause may be the Volume Gear Mesh failure, Volume damage, etc. Replace the Volume in
the following procedure. Explanations of Volume replacement in the X direction are given below.
The Volume in the Y direction is the one to be removed when replacing the Torsion Spring. Prepare a
philips type screwdriver for M4 screw and flat-blade type screwdriver for M3 Cheese Head.
Turn the power off and open Control Panel.
Disconnect the Volume Connectors.
The red one is the connector in the X direc-
tion, and the blue one is the Volume in the Y
direction.
Take out the 2 screws and remove the Vol-
ume together with the Bracket.
Take out the 2 Set Screws and remove the
Gear.
Replace the Volume. Assemble by using the
oppisite procedure.
At this time, cause the gears to be engaged in
the periphery the center of the Volume’s
movable range when the reel is positioned at
the center.
Turn power on and perform Volume setting
in the Test Mode.
1
2
3
4
5
6