The raft printed for this example is
exaggerated in size for illustration
purposes. The image on the right
shows the part as printed on the raft.
Below that is the part after separation
from the raft. The part is upside down
so you can see the bottom surface.
•
None
No action is taken.
Special Modes
contains parameters that don’t necessarily have a home in the other
categories. There are a number of special modes you can work with, but in the “default” mode,
only
Print Sequence
is enabled. It has two settings,
All at Once
and
One at a Time
. When
set to
All at Once
, all parts will be printed at the same time – meaning the first layer for all parts
will be printed, then the second, third, etc. With
One at a Time
set, each part on the build plate
will be fully printed before the next part is printed. This is only possible if the previously printed
parts do not block the movement path for subsequent parts. It’s recommended that you leave
this set to
All at Once.
23
