To print your newly uploaded file, just locate the filename in the list and click on it.
When you click on the link, you’ll be presented with a confirmation dialog as shown
below. Click on the
Yes
button to start the print!
With the start of the print job, the printer is going to heat up the heated bed first, and then
the hot end. As you can see below, it’s currently heating the bed.
The
Active
column shows
the target temperature while the
Current
column shows the actual
temperature as measured by the
controller. When the target
temperature is reached by the bed,
the printer will begin to heat the hot
end. Once
that
temperature is
reached, the print job will begin!
The following pages show the results of this print job. I’ve increased the size of the part
to 50mm in order to make it more easily seen.
15
Filename link
Start Print confirmation dialog.
Bed heat active.
