Security Command 670, User Manual, Page: 10 / 32

8
Step By Step: Step By Step: Step By Step: Step By Step: Step By Step:
1. Press the key until ARM DISARM ARM DISARM ARM DISARM ARM DISARM ARM DISARM is displayed.
ARM
2. Press to arm areas.
3. Enter your code number if required. The display will read
ALL NO YES ALL NO YES ALL NO YES ALL NO YES ALL NO YES
NO
4. Press
to arm selective areas. Go to step 5.
YES
Press to arm all areas to which you have access. Go to step 6.
5. If NO is selected in step 4 the display will list each area to which you have
access, followed by NO and YES. Example: OFFICE NO YES OFFICE NO YES OFFICE NO YES OFFICE NO YES OFFICE NO YES
YES
5a. Press
for every area you wish to arm.
NO
5b. Press
for every area you do not wish to arm.
6. Loops which have been bypassed prior to arming and bad 24 hour loops will
be displayed. No action is required by you.
7. Bypass any bad loops if required (step 7a, 7b, 7c)
7a. If a problem exists on one or more loops, the loop name and problem will
be displayed followed by BYPASS? NO YES
BYPASS? NO YES BYPASS? NO YES BYPASS? NO YES BYPASS? NO YES
NO
7b. Select
to stop the arming sequence without bypassing
any loops. Correct the problem and return to step 1.
YES
Select to bypass all loops displayed as bad.
7c. Enter your code number if required to bypass loops.
8. The display will read SYSTEM ON SYSTEM ON SYSTEM ON SYSTEM ON SYSTEM ON
system is armed, and ALL SYSTEM ON ALL SYSTEM ON ALL SYSTEM ON ALL SYSTEM ON ALL SYSTEM ON if all areas in the system are
armed.
9. The exit time will be displayed in seconds and begin counting down,
EXIT : XX EXIT : XX EXIT : XX EXIT : XX EXIT : XX . When the delay expires the exit loops will be armed.
if at least one area in the
AREA SYSTEM ARMING
COMMAND