SD-EN-030 28 / 40 V1.0
4.7.
Panel Setting
‘
Panel Setting
’ is designed for
user to bind the output to the G265 transceiver.
By either clicking ‘
Panel
Setting
’ or double
-
clicking a certain panel component in the ‘
UI Design Area
’,
user can enter this page.
4.7.1.
Scan Output
By clicking ‘
Scan Output
’, the
G265 transceiver (RX) in the same network
will show in the ‘
Output List
’.
4.7.2.
Bind windows to outputs
(1) Choose a panel from the ‘
Panel
’ list on the left;
(2) Choose the device in the ‘
Output List
’ on the right;
(3) Click on the panel in the middle. When there is an IP address displayed in the middle of the panel, the
panel setting is done.
Basic Attribute: Config the number of rows and columns for the output panel.
Position/Size: Config the position and size of windows for the output panel.
4.7.3.
Mode
User can also set up the grid layouts (modes) for the selected panel. The designer software provides a
maximum of 8 preset grid layouts. By choosing one of these
modes and clicking ‘
Add
’, the
panel will light
up and user can then config the mode.
Basic Attribute: User can change the name of the current mode. By entering contents
in the form of ‘
AxB
’,
for example, ‘
2x3
’
, the output panel will be divided into 2 rows and 3 columns by grids. To disable a mode,
enter ‘
0x0
’ in ‘
Divide
’.
Position/Size: When one window in the output panel is selected, the position and size of this window can
be modified. User can also set up how signals are being streamed (main-stream/sub-stream) in this
window. User can delete certain windows and
change the size of other windows to achieve the ‘
merge
’
of windows. The customised modes can then be used in the G265 Client.
4.7.4.
Audio Follow
User can bind a transceiver
with the output panel to provide audio from the output. Choosing ‘
Audio
Follow
’, clicking ‘
Add New
’, clicking on the output panel in the
middle and choosing a transceiver from
the ‘
Output List
’ can easily bind the transceiver with the output panel. User can then
use the slider
component and get back compeont to observe and control audio volume for the output panel.
Note that user needs to u
se the UMPlatform to switch the audio between ‘HDMI’ and ‘3.5mm’.
