SEABOB CAYAGO F7, Operation Manual, Page: 33 / 82

| P
age 33
|
SEABOB
Operation
Manual
|
5
Ensure that the contacts between the SEABOB
housing and the accumulator box ACS are always
kept perfectly clean and dry. Only use Klüber Kontasynth
BA 100 special lubricant to ensure that the electrical con-
ductivity of the high-current contacts is not diminished
and that no chemical reactions are triggered which could
corrode the sealing rings, thereby reducing the effective-
ness of the seal.
Caution! Dirty and / or damaged seals can reduce
the effectiveness of the seal.
Ensure that the seals on the SEABOB and the sealing
frame on the accumulator box ACS are clean, free of
scratches and scoring and undamaged. Check this ad-
ditionally if necessary by taking your finger (your finger
should be clean) and feeling around the sealing surface
of the sealing frame and quad ring. Use only the special
lubricant specified above to spray and preserve the seals.
3. Lower the SEABOB housing onto the accumulator box
ACS at a distance of approx. 10 cm from the craft‘s
bow.
4. Slide the SEABOB housing forward, moving it over
the accumulator box until the attachment bolts near
the bow are seated correctly in the attachment holes
of the housing and the high-current connector plate
the latest after changing the accumulator ten times,
you should also spray the sealing surfaces and con-
tact surfaces with Klüber Kontasynth BA 100 special
lubricant. Perfectly clean, scratch-free and moistened,
the sealing frame of the accumulator box should fit
smoothly over the quad ring, which should also be
perfectly clean, scratch-free and moistened.
2 1
3
4
High-current contact plate
on accumulator box ACS
High-current connector
plate in accumulator shaft
High-current connector
plate on SEABOB ACS
Sealing frame on the
accumulator box ACS
Quad ring on
SEABOB ACS
Spacer O-ring on
SEABOB ACS