SEABOB CAYAGO F7, Operation Manual, Page: 11 / 82

| P
age 11
|
SEABOB
Operation
Manual
|
1
• Before charging the accumulator box, check that the charging socket and charg-
ing plug are perfectly clean and dry. Never open the sealing cap on the accumu-
lator box charging socket while the SEABOB is in the water. Wet and / or dirty
plug connections may cause a short circuit while the accumulator box is being
charged or even before this process is begun. If a short circuit occurs, it can cause
irreparable damage to the charging contacts of the SEABOB. Caution! Short cir-
cuits can cause fires.
• Always ensure that the Powergrip is functioning properly. When you release the
Powergrip, the SEABOB should immediately switch off. The Powergrip should be
able to move freely in all positions. When released, it should always return un-
obstructed forward to the Off position. A damaged, sticking or bent Powergrip
should be repaired or replaced immediately. If the Powergrip is not functioning
properly, you can stop the motor by tapping the red button repeatedly until the
power is displayed as "0 %".
• Never stick sharp objects into the depth sensor or do anything else that could
damage the depth sensor. Prevent all dirt, sand, polish or other material from
getting into the water inlets on the depth sensor. A damaged depth sensor or
dirty inlets can impair operation of the device, even leading to complete failure.
Always rinse out the depth sensor thoroughly with fresh water to prevent the
build-up of salt deposits. Use a garden hose or similar equipment for cleaning.
Never use a high-pressure hose or steam jet. If the depth sensor is damaged or
the inlets are dirty, the motor’s safety cut-off will not function at the set maxi-
mum diving depth (default setting 2.5 m). This may damage the health of the
user.
• Never open the SEABOB yourself. Repairs and maintenance work on the SEABOB
that go beyond the procedures described in Chapter 6 "Care" and Chapter 7
"Troubleshooting" may only be carried out by an authorised technician. Work
of this type is dangerous and may result in severe injury or cause damage to the
SEABOB if not carried out by an authorised technician.
• Never alter or modify any part of the SEABOB, accumulator box or charger. Doing
so may result in serious injury or death.
• If you detect any damage to the SEABOB, in particular to the accumulator box,
charging socket and sealing cap, or seals between the SEABOB and accumulator
box ACS (Accumulator Change System), immediately stop operating the device
and contact the manufacturer or your specialist dealer.